Skip to main content Skip to footer 
Our Blog
Metal Surface Finishing Guide: How to Choose the Right Finish for Your Parts
Choosing the wrong surface finish can turn a perfectly machined part into a failed part. An aluminum component may meet every dimensional requirement after machining, yet develop fit problems after…
Hard Anodizing vs Regular Anodizing: Type II vs Type III
Hard anodizing is not simply a thicker version of regular anodizing. Regular Type II anodizing is typically chosen for appearance, color, and corrosion protection, while Type III hard anodizing is…
Investment Casting Process: From Wax Pattern to Finished Precision Parts
Investment casting, also known as lost wax casting, is a precision metal-forming process used to manufacture complex components with good dimensional accuracy, surface finish, and repeatability. The basic principle is…
What RoHS and REACH Restrictions Affect Material Selection for Swiss CNC Parts Imported into the USA?
We have turned away orders that looked simple on paper — a brass connector, a leaded steel pin — only because the destination assembly was covered by RoHS. That experience…
How Do You Verify That a Chinese Factory Is Using the Exact Material Grade Specified on Your Drawing?
We have seen it happen more than once. A purchasing manager sends a drawing clearly calling out 316L stainless steel 1. Parts arrive. They look right. They measure right. Then…
Does Black Oxide Treatment Provide Adequate Rust Protection for Swiss CNC Parts Used Outdoors or in Humid Environments?
We see this question on almost every RFQ where black oxide is listed as the default finish — and the answer almost always surprises buyers. Black oxide creates a magnetite…
