Skip to main content Skip to footer 
June 15, 2026We have seen this situation many times across our supply chain operations: a customer sends a drawing with the note…
June 15, 2026We have seen too many shipments arrive with a single line on the packing list: "Material: D2 tool steel. Heat…
June 15, 2026In our workshop, we see this problem often. A customer sends a perfect drawing. The part comes back slightly out…
June 12, 2026We see this problem on nearly every new project: a drawing arrives with a note that says "parts shall be…
June 12, 2026We have shipped wire EDM parts to North American clients for years. One thing we see repeatedly: buyers assume their…
June 12, 2026We have rejected more shipments over plating non-conformance than almost any other defect category. The parts look fine. The supplier…
June 12, 2026At our wire EDM workshop, we get this question from US buyers almost every week. Many assume coating happens under…
June 12, 2026We have seen it happen more times than we would like to admit. A batch of wire EDM parts passes…
June 12, 2026We source wire EDM parts from factories across China and Vietnam every week. When a client sends drawings with a…
June 12, 2026Every week, we see EDM parts arrive at the coating shop and get rejected — not because the machining was…
June 12, 2026At our factory, rust spots on freshly cut wire EDM parts1 always raise a red flag before shipment. Left untreated,…
June 11, 2026Every week, parts come through our workflow that were wire EDM 1'd with precision — tight tolerances, clean edges, beautiful…
Get A Quote
